Below-ground structures face constant hydrostatic pressure. Understanding where that pressure finds a path explains almost every basement leak we are called to.
Permanent pressure, not occasional
Unlike a roof, a basement wall is under continuous hydrostatic pressure whenever the water table is above slab level. Water does not need a defect to exploit — it needs only a path.
The usual paths
Construction joints between pours, tie-rod holes left from formwork, cracks from early thermal contraction, and service penetrations. These four account for the large majority of basement leaks we are called to.
Why external repair is rarely practical
Excavating around an existing building is disruptive and expensive, and often impossible where the structure is against a boundary. This is why remedial basement work is almost always carried out from inside using injection.
A system, not a coating
A coating applied over an active leak will be pushed off by water pressure. The sequence has to be: arrest the flow by injection, then apply a negative-side tanking system, then finish. Reversing that order is why so many basement repairs fail.
In Practice
What This Means For Your Building
The condition has to be assessed on site before a system is specified. HAVEN FORCE reviews the substrate, the exposure and the way the defect is presenting, then recommends a treatment matched to what is actually happening rather than to the symptom alone.
- Assess the condition on site before specifying a system
- Identify the mechanism, not only the visible symptom
- Match materials to substrate, exposure and expected performance
- Prepare, apply and inspect to a documented standard