Wet Area Waterproofing by HAVEN FORCE Technical Services in Dubai
Waterproofing Solutions

Wet Area Waterproofing

Protection Where Water Lives

Bathrooms, kitchens, laundries and balconies see water every day, and the tanking beneath the tiles is what keeps it out of the structure. HAVEN FORCE installs wet area waterproofing with full detailing at falls, drains and junctions before tiling begins.

Tanking
Beneath Tiles

Junction
Detailing

Mould
Prevention

Long-Life
Protection

Common Problems

What We Typically Find

The conditions most often reported before a wet area waterproofing scope is developed.

01

Damp on the wall the other side

Water passing through the tanking layer and into the adjacent room.

02

Staining on the ceiling below

Wet area failure showing up on the floor beneath.

03

Loose or drummy tiles

Water sitting behind the tiles and breaking the adhesive bond.

04

Perished sealant at junctions

Movement joints opening up at wall-floor corners and around fittings.

Scope & Application

What This Service Covers

Service Scope

  • Removal of existing finishes where required
  • Substrate repair and levelling
  • Setting falls to drainage
  • Primer application
  • Liquid tanking membrane in two coats
  • Reinforcement at corners and junctions
  • Drain and penetration detailing
  • Flood testing before tiling

Suitable For

  • Bathrooms & Ensuites
  • Kitchens & Pantries
  • Hotel Wet Rooms
  • Laundry Areas
  • Balconies & Terraces
  • Clinical Wash Areas

Key Benefits

  • Prevents water reaching the structure
  • Reduces mould and odour
  • Protects adjacent rooms
  • Long service life beneath tiling
  • Avoids costly strip-out later
  • Suitable for renovation and new build
  • Detailed at every junction
  • Flood tested before handover
Our Process

Work Methodology

Five controlled stages from first inspection to final quality check.

Strip & Assess — Wet Area Waterproofing
1

Strip & Assess

Remove finishes as needed and inspect the substrate and existing falls.

Substrate Preparation — Wet Area Waterproofing
2

Substrate Preparation

Repair, level and set falls so water runs to the drain.

Membrane Application — Wet Area Waterproofing
3

Membrane Application

Prime, then apply the tanking membrane in two full coats.

Reinforcement & Detailing — Wet Area Waterproofing
4

Reinforcement & Detailing

Band all corners, junctions, drains and pipe entries.

Flood Test — Wet Area Waterproofing
5

Flood Test

Hold water on the area and confirm it is tight before tiling.

Materials & Systems

Specified To The Condition

Systems are selected according to substrate, exposure and project specification. The final specification is confirmed after a site assessment.

Liquid Applied Tanking

Flexible, seamless membrane that follows complex shapes and detailing.

Reinforcing Tape

Bonded into corners and junctions where movement concentrates.

Epoxy Tile Grout

Impermeable grout for areas under heavy or constant water exposure.

Gallery

Work In Progress

Wet Area Waterproofing — site photograph
View
Wet Area Waterproofing — site photograph
View
Wet Area Waterproofing — site photograph
View
Wet Area Waterproofing — site photograph
View
Full Gallery
FAQs

Questions About Wet Area Waterproofing

Usually yes. Tanking sits beneath the tiles, so reaching it means lifting the finish in the affected area.
Typically a few days including curing and flood testing, depending on area and the extent of substrate repair.
Wherever practical. It is the only reliable way to confirm the tanking holds before tiling covers it.
WhatsApp Call Us